Rexroth Pump

Project planning notes:The A10VSO axial piston variable pump is designed to be used in open circuit.The project planning, installation and commissioning of the axial piston unit requires the involvement of qualified skilled personnel.The specified data and notes contained herein must be observed.Depending on the type of control used, electromagnetic effects can be produced when using solenoids. During and shortly after operation, there is a risk of getting burnt on the axial piston unit and especially on the solenoids.

Permissible radial and axial forces of the drive shafts.Permissible input and through-drive torques.Over the years, we have been committed to the production and research of Rexroth A10VSO Series 31 Axial piston variable pump .We not only provide high quality machinery and accessories for sale on the market, we also care about customers’ profits and the impact of machinery on the environment.

DG – Two-point control, direct operated、DR – Pressure controller 、DRG – Pressure controller, remote controlled、ED7., ER7. – Electrohydraulic pressure control. Over the years, we have been committed to the production and research of Rexroth A10VSO Series 31 Axial piston variable pump .We not only provide high quality machinery and accessories for sale on the market, we also care about customers’ profits and the impact of machinery on the environment.If you want to know more details, please contact us immediately!

DG – Two-point control, direct operated .The variable pump can be set to a minimum swivel angle by connecting an external switching pressure to port X. DR – Pressure controller. The pressure controller limits the maximum pressure at the pump outlet within the control range of the variable pump. The variable pump only supplies as much hydraulic fluid as is required by the consumers. If the working pressure exceeds the pressure command value at the pressure valve, the pump will regulate to a smaller displacement to reduce the control differential. DRG – Pressure controller, remote controlled. For the remote controlled pressure controller, the LS pres- sure limitation is performed using a separately arranged pressure relief valve. Therefore any pressure control value under the pressure set on the pressure controller can be regulated.

Permissible radial and axial forces of the drive shafts. The values given are maximum values and do not apply to continuous operation. Drives with radial loading (pinion, V-belt drives) are not permissible!Permissible input and through-drive torques.

Working pressure range : The nominal pressure corresponds to the maximum design pressure.Minimum pressure on the high-pressure side (B) which is required in order to prevent damage to the axial piston unit. Minimum pressure at suction port S (inlet) that is required in order to avoid damage to the axial piston unit. The minimum pressure depends on the rotational speed and displacement of the axial piston unit.

The A10VSO variable pump is designed for operation with HLP mineral oil according to DIN 51524. Application instructions and requirements for hydraulic fluids should be taken from the following data sheets before the start project planning:90220: Hydraulic fluids based on mineral oils and related hydrocarbons 、90221: Environmentally acceptable hydraulic fluids、90222: Fire-resistant, water-free hydraulic fluids (HFDR/HFDU) (for permissible technical data, see data sheet 90255)、90223: Fire-resistant, water-containing hydraulic fluids (HFAE, HFAS, HFB, HFC)、90225: Restricted technical data only for operation、with fire-resistant, water-free and water-containing hydraulic fluids (HFDR, HFDU, HFB, HFC)- technical data.